From:Steve Marks e-mail:steve@themagnetoguys.co.uk
Subject:RE: RE: Coil for a Scintilla AP4 magneto Date:Tue Sep 3 04:54:05 2019
Response to:7154


----- ORIGINAL MESSAGE FOLLOWS -----
......The Scintilla looks like it uses a fairly simple
wound coil, so anyone with a coil winding lathe should be
able to produce one - 'all' it takes is a steady hand and
a mile or so of fine wire.......

Rohan!!!!
Yes 'anyone' can wind a coil but will it work afterwards?
It is a bit more involved than what your post suggests
though I accept that you were probably writing it 'tongue
in cheek'!! If anyone is interested enough to want to have
a go, this might be helpful:
https://www.themagnetoguys.co.uk/Rewinding-Magneto-Coils
https://www.themagnetoguys.co.uk/rewinding-magneto-coils--
-materials
And once you've done the winding, you then need to do the
vacuum impregnation process
https://www.themagnetoguys.co.uk/vacuum-pressure-
impregnation

Good luck!
Steve

Sent from IP Address: 159.180.114.174
Lookup 159.180.114.174