From:Rick Yamane e-mail:rick@motionpro.com
Subject:RE: RE: dampening springs on Deluxe Date:Thu Jun 6 18:11:29 2019
Response to:7090
I think I used a couple of ratcheting tiedowns. I thought
I might have photos but I don't. I do remember it was a
PIA and I was relieved to be done.

----- ORIGINAL MESSAGE FOLLOWS -----
Doug Rollert told me how he did it, sounds easy, but I'm
not
there yet. First, make a wedge that fits around the stem
and
between the cap and the fork of the stem. Needs to be
just
thick enough to allow the main spring, washer and nut to
go
on. Crank the nut down, compressing the spring, add the
lock
nut and then screw onto the spring tube. This should
allow it
to start at least. As you screw it down, the spring will
compress and the stem will rise up and the wedge can be
removed. I can picture all this in my head, hope it makes
sense.

----- ORIGINAL MESSAGE FOLLOWS -----
Just got a couple springs to install on my 25 Deluxe.

Anyone have instructions on a good approach to installing

The two springs. I can see it is going to be a
compressing
job that someone out there has a tried and proven method.
Thanks for the help
Andy

Sent from IP Address: 173.8.185.186
Lookup 173.8.185.186