From: | Bob Whittingstall | e-mail: | bob@camtrans.com.au |
Subject: | RE: RE: RE: RE: 1918 Manifold | Date: | Sun Dec 23 21:54:27 2018 |
Response to: | 6973 |
Thanks Mike I have 2 manifolds 1 with holes in it and 1 without I have been using the 1 with holes and have problems over fueling on the no 3&4 cylinders will try the 1 without Thanks for your help have a good Christmas Regards Bob ----- ORIGINAL MESSAGE FOLLOWS ----- Bob, the manifold has a straight baffle lengthwise down the inside center of the manifold. It starts at the rear and ends even with the front of the #2 port. I did not see any holes drilled. So I must be missing something? ----- ORIGINAL MESSAGE FOLLOWS ----- Thanks Mike there are 2 holes in the inlet manifold to allow gas to flow they are drilled in the inside wall where the third and forth cylinders are hope this makes sense or I will upload a photo Regards Bob ----- ORIGINAL MESSAGE FOLLOWS ----- Bob, can you clarify your question? I can take any measurements you need off a manifold in the shop, Mike ----- ORIGINAL MESSAGE FOLLOWS ----- Hi all does anyone know the hole sizes drilled into the manifold for the third and forth cylinders |