From:Mike Lynch e-mail:Mikeslynch@hotmail.com
Subject:RE: RE: RE: 1918 Manifold Date:Sun Dec 23 14:31:16 2018
Response to:6969
Bob, the manifold has a straight baffle lengthwise down the inside center of
the manifold. It starts at the rear and ends even with the front of the #2 port.
I did not see any holes drilled. So I must be missing something?

----- ORIGINAL MESSAGE FOLLOWS -----
Thanks Mike there are 2 holes in the inlet manifold to allow gas to flow they
are drilled in the inside wall where the third and forth cylinders are hope this
makes sense or I will upload a photo

Regards Bob

----- ORIGINAL MESSAGE FOLLOWS -----

Bob, can you clarify your question? I can take any measurements you need
off a manifold in the shop,
Mike
----- ORIGINAL MESSAGE FOLLOWS -----
Hi all does anyone know the hole sizes drilled into the manifold for the third
and forth cylinders