From:Bob e-mail:bob@camrtrans,com.au
Subject:RE: RE: 1918 Manifold Date:Wed Dec 19 02:38:26 2018
Response to:6968
Thanks Mike there are 2 holes in the inlet manifold to allow gas to flow they are drilled in the inside wall where the third and forth cylinders are hope this makes sense or I will upload a photo

Regards Bob

----- ORIGINAL MESSAGE FOLLOWS -----

Bob, can you clarify your question? I can take any measurements you need
off a manifold in the shop,
Mike
----- ORIGINAL MESSAGE FOLLOWS -----
Hi all does anyone know the hole sizes drilled into the manifold for the third
and forth cylinders