From:bill klen e-mail:wmgkle@swbell.net
Subject:RE: Zenith Carb Venturi Replacement Date:Tue Jul 17 07:51:55 2018
Response to:6895
Hold the carb body in a vise. Put your hacksaw blade through the carb and attach to your hacksaw frame. Carefully cut through the venturi in one or maybe 2 places. The venturi will fold in and is easy to remove.

----- ORIGINAL MESSAGE FOLLOWS -----
Anyone have any advice on replacing the old venture on a Zenith T4x ? I was thinking using an end mill on a Bridgeport but wasn't sure if the carb housing is too delicate ?
As always,
thanks
Dan