From:KAZU e-mail:kwest2424@gmail.com
Subject:RE: RE: RE: KJ's numerically. Date:Mon Jan 18 22:39:03 2016
Response to:6027
Very Thanks Rick
I've just got 2.653" Is this nearly number??
I will try to make Main shaft and Gears here in japan
They need that number that make less Back rush gears.
Thank you



----- ORIGINAL MESSAGE FOLLOWS -----


----- ORIGINAL MESSAGE FOLLOWS -----


----- ORIGINAL MESSAGE FOLLOWS -----
Hi, everyone I need help,,,
I would like to know Accurate distance between
spline shaft(main shaftjand countershaft gear of these
center ? or How to measure? Thanks,,,

Depends on what stage of assembly you are looking at but the
principles are the same. If the shafts are in place use a
suitable caliper and measure from the backside of one to the
backside of the other then do the same from frontside to
frontside. Add the two values and divide by two.
You can do the same if you are looking at the bores for or
in the bearings.

Rick