From:Steve e-mail:Nastycough@gmail.com
Subject:RE: RE: RE: RE: ACE springs Date:Wed Jun 10 02:04:33 2015
Response to:5595
I'm also trying to figure out seat springs for my 20 ace and it turns out they
are really similar to 1919 Henderson

I was wondering if ace put a different number of coils one side of the seat
because of sidecars

My seat is incorrect and my springs are broken but they have a strap
around the outside of the spring from top to bottom

Are these ace seat springs?

----- ORIGINAL MESSAGE FOLLOWS -----
My choice of wood is a good hickory or ash. What's good
enough to make baseball bats should suffice for the front
end of an Ace. I'd love to have a section of rare American
Chestnut, Castanea dentata, as I have a sizeable specimen in
my yard but don't wish to start cutting limbs off my
favorite tree. However I did peek inside my spring fork and
was quite confounded when I actually saw a set of springs in
there.

Attached is a photo of the short, or rebound springs.
Notice the difference. I assume the heavier wire spring is
earlier as related to me by Joe Stephen. I have a set of
compression springs that show the same "evolution".

----- ORIGINAL MESSAGE FOLLOWS -----
Thanks Doug. I was sure I could rely on you but asked here
for two reasons: one, I knew you subscribed and two, others
might benefit from the answers too! For instance, I bet not
many knew of the wooden block (I didn't) - all we need to
know now is type of wood and dimensions so that I can get
near to the 100 points! Look forward to getting the info on
the springs. You can probably guess that the Ace project is
finally back underway (at last) following pressure from a
few locals!! Thanks again - Steve

----- ORIGINAL MESSAGE FOLLOWS -----
Steve. You didn't consult with Doug's One Stop Ace Shop.
I'll get you the dimensions you need. No problem.

Here's a little story for you. When Joe Stephen was working
at Ace, he rode a Reading Standard with sidecar as he
couldn't afford an Ace. One day Bill Henderson borrowed his
RS to run an errand. Joe stated that in about 2 weeks he
noticed the rides on the Aces were noticably softer in the
front. I swear the factory put a block of wood inside my
spring fork on my 1921 Ace.

----- ORIGINAL MESSAGE FOLLOWS -----
Hi Guys
Hope someone can help with some info on spring dimensions
for a 1924 Ace please.
My (almost complete kit) Ace is missing both springs in the
front fork. I need the diameter of the wire, the outside
diameter of the coils, the free length of the coil and the
number of turns for each of the two springs. Then I can get
some made. Please don't take your forks apart for this - I'm
hoping someone will have a set of forks already dismantled!
The other springs I need are the seat springs. Now, you
would think this would be easier but counting the number of
coils on pictures of Aces found on the internet and in the
books give numbers varying from eight to sixteen.... Just
wondering what the originals had? My Ace is 1924 so I think
I need the single spring each side rather than the later
double spring arrangement but please correct me if I'm
wrong!
Thanks in advance for any help you can give
Best regards - Steve