From:graeme staples e-mail:spydaman@ihug.co.nz
Subject:RE: RE: crankshaft end float specification Date:Mon May 12 04:38:03 2014
Response to:5160


----- ORIGINAL MESSAGE FOLLOWS -----
I set mine in at .002 to .004 thousands of a inch A.S.E.
standard is .002 to.006 thousands of an inch. The hen info I
have seen says no end play. I leave some room for it to grow.

Mark

----- ORIGINAL MESSAGE FOLLOWS -----
crankshaft end float K henderson, i'm keen to know what the
specification should be for these as i rebuild my 1921 bottom
end. thanks

thanks for your prompt help Mark. Graeme